Kenny, I have asked questions on this subject before and still dont have much of a clue. You said,
Quote:
No kite looping is required, you just have to keep the kite moving rapidily overhead between 11 and 1.
I understand not "sending" sending the kite. I understand the lift. Does the turning the kite back and forth from 11 to 1 keep you up for a longer time?
What keeps you going down the hill and going upwind while in the air? Is it this back and forth motion, or just the momentum generated from skiing/boarding fast down the hill?
If you just "send" the kite, do you just go up, float down wind (back up hill), not upwind and down the hill? I've wondered why chasta and you guys are going away from the hill upwind and not floating downwind like when you "send it". Is momentum the key, or 11 to 1, or both?
Les,
I was wrong about moving the kite between 11 and 1. If you do a glide that is directly into the wind, you just keep the kite at zenith. I am getting far better glides with the kite planted overhead than I did swinging the kite back and forth.
Here are a review of the steps for gliding:
1. Fly a big kite. I weigh 180 LBS and I use a 17M foil.
2. Check the wind direction. You want to glide where the wind is going directly up the hill or you can fly slightly cross to the wind.
3. Start at the top of a hill with the kite at 11:30 and the bar sheeted-out. Point your board/skis directly downhill/upwind. As you gain speed, you will start feeling lift from the kite.
4. Move the kite to zenith and sheet-in the bar. You should lift off of the hill.
5. Once I am in the air, I like to turn my body 180 degrees so that I am facing the hill. I like this position because I have a better feel for the steering. Rob W. with Ozone likes to face forward, the trick is to steer the kite properly.
6. While you are in the air, you only have to steer your kite if you feel that you are losing altitude rapidly. If this happens a quick pull to either side will put the kite into the power zone and slow your descent. The other control that you have in the air is sheeting the bar in/out. Sheet-in for maximum lift and to slow the descent, sheet-out for more speed. I find that I usually sheet-in to gain initial altitude then I sheet-out during much of the glide, then sheet-in when I am about 10 feet off the deck for landing.
7. As I just mentioned, sheet-out to slow your descent (similar to a flare in paragliding). I also like to steer the kite to 10, this motion powers the kite in the opposite direction of my descent slowing me for landing and keeping the kite from overflying during landing. I sometimes turn my body so that I am facing forward, other times I land switch.
Gliding with a kite is basically the same as flying a small paraglider. The only difference is your body's proximity to the kite. If you are interested in learning more, read up of the basics of paragliding. The priniciples are the same.
Bosco hill at Skyline is excellent for glides. Either from the top of the north side or near the bottom on the south side. The later is probably the best place to learn. PowMow also works, but you have to watch out for trees!
Kenny